Sc boot Command in Windows Server 2008
In this article I am going to explain about sc boot command in windows server 2008 operating system.
Introduction
The operating system Sc boot command is used to indicates whether the last boot should be saved as the last-known good boot configuration.
Syntax of Sc boot command
sc [<ServerName>] boot [{bad | ok}]
|
Parameters in Sc boot command
It contains following parameter, which is given below:
Parameter |
Description |
<ServerName> |
It specifies the name of the remote server on which the service is located. The name must use as the Universal Naming Convention (UNC) format |
bad | ok |
It specifies whether the last boot was bad or whether it should be saved as the last-known good boot configuration. |
Example of Sc boot command
sc boot
sc boot ok
sc boot bad
|
Output: