Sc failureflag Command in Windows Server 2008
In this article I am going to explain about Sc failureflag command in windows server 2008 operating system.
Introduction
The operating system Sc failureflag command is used to specifies whether recovery action will be trigged when a service stops as the result of an error.
Syntax of Sc failureflag command
sc [<ServerName>] failureflag [<ServiceName>] [<Flag>]
|
Parameters in Sc failureflag command
It contains following parameter, which is given below:
Parameter |
Description |
<ServerName> |
It specifies the name of the remote server on which service is located. |
<ServiceName> |
It specifies the service name. |
<Flag> |
It's default value is zero(0). |
Example of Sc failureflag command
Output: